Descargar Imprimir esta página

GreenWorks STC459 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
8.
Align the spool tabs with the tab openings on the
spool housing.
9.
Push the spool cover assembly until it clicks into
position.
6.4
INSTALL THE CUTTING LINE
Note: Do not use more than 23 ft. (7 m) of 0.095" (2.4
mm) cutting line at a time.
1.
Remove any leftover cutting line from the trimmer
head.
2.
Push and turn the spool cover. Ensure that the
slot (1) on the spool cover aligns with the line exit
hole on the trimmer head.
3.
Feed the cutting line through the hole and push it
until it exits the opposite hole.
4.
Pull the cutting line through until there is an equal
amount of cutting line on each side.
English
5.
Turn the spool cover clockwise to wind the cutting
line into the trimmer head. Keep approximately
5" of cutting line above out of each side of the
trimmer head.
1
7
TRANSPORTATION, STORAGE, AND
DISPOSAL
7.1
TRANSPORTATION AND STORAGE
• Follow special packaging and labeling requirements
for commercial transportation, including by third
parties and forwarding agents.
• Seek advice from a person with special training in
dangerous materials before shipping the product
and comply with all applicable national regulations.
• Use tape on open contacts when packaging the
battery and ensure it is securely packed to prevent
movement.
• Remove the battery before storing or transporting
the product.
• Store the battery and battery charger in a dry,
moisture-free, and frost-free space.
• Avoid storing the battery in an area where static
electricity may occur, and do not store in a metal
box.
• Charge the battery 30% to 50% before long-term
storage.
• Store the battery charger in a closed and dry space.
• Keep the battery away from the battery charger
during storage, and ensure that unauthorized
persons, including children, do not touch the
equipment. Store the equipment in a lockable
space.
12

Publicidad

loading