Vaisala Indigo510 Guía Rápida página 20

Attaching probes
CAUTION!
CAUTION!
attached to the probe connection cable.
If you want to configure the probe settings, such as purge interval, you must do
that before attaching the probe to the transmitter. To configure the probe, you
can use the free Vaisala Insight PC software. For more information, see your
probe's user guide and visit www.vaisala.com/insight.
If your transmitter was delivered with preconfigured analog outputs, make sure
that you connect the probes accordingly. See the label inside the transmitter
enclosure for the correct order of the probes.
When the probe connection cables have been wired to the transmitter, you can attach and
detach probes both when the transmitter power is on and when it is off. If the power is on
while you attach or detach a probe, the transmitter shows a notification about the probe. If
you have configured the transmitter to use outputs, the transmitter also notifies you of the
state of the outputs.
18
Attach only Vaisala Indigo compatible probes to the transmitter.
The IP classification of probes is valid only when the probes are
M212290EN-D