Graham Field LUMEX 7108A Manual De Instrucciones página 3

Inserting Back Support
1. Remove back support from carton.
2. Insert back support into channel guides until back support locking buttons click into place in
channel guide holes.
WARNING: Ensure that locking buttons protrude fully through holes before use.
Use Commode over Toilet
1. Set commode to desired height (described in previous steps).
2. Remove commode pail and lid.
3. Position splash guard in place on pail supports.
4. Remove back support (described in previous steps).
5. Lift toilet bowl seat.
6. Place commode over toilet with splash shield positioned over the center of the toilet bowl.
Commode is now ready for use. Clean seat and splash guard with disinfectant after each use.
Use as Bedside Commode
1. Set commode to desired height (described in previous steps).
2. Lift commode seat and lid and place commode pail on pail supports. Ensure that pail is
properly positioned below commode opening.
3. Place commode seat down. Commode is now ready for use.
4. When user is finished using commode, place commode pail lid over commode pail to
contain odors.
5. Remove pail and lid simultaneously to empty pail. Clean seat and pail with disinfectant after
each use.
MAINTENANCE
WARNING: Inspect frequently to ensure that all attaching hardware is tight.
WARNING: Inspect rubber tips on the leg extensions for rips, tears, cracks or wear
or if they are missing. Replace them IMMEDIATELY if any of these conditions exist.
s NOTICE: Never use organic solvents, abrasive cleaners, or scouring pads on any
part of the product.
After each use: Dry with a soft cloth.
Cleaning: Use a mild soap and water solution, rinse with clear water, then dry with a soft cloth.
Ensure that product is well rinsed before using.
To guarantee the best service from your product, always specify Lumex replacement parts,
available from your GF Health Products, Inc authorized distributor.
LX_7108-INS-LAB-RevC23
www.grahamfield.com 3