Mitsubishi Electric MSZ-FH09NA Manual De Instrucciones página 4

• OPERATING INSTRUCTIONS •
I
Indoor unit
Front panel
Air filter --
(Nano platinum
filter)
Air cleaning filter
(Electrostatic
anti-allergy Horizontal
enzyme filter and vane
deodorizing filter)
Air outlet
//
////
/ /
inlet
Emergency
switch
.... i-see sensor
i=
L_ emote control receiving
section
Outdoor unit
Air inlet (back and side)
-- Piping
-- Drainage hose
Air outlet
Drain outlet
Outdoor units may be different in appearance.
Remote controller
Battery replacement indicator
Operation
display section
Temperature
buttons _
Operation
ECONO COOL
button
POWERFUL
button
nal transmitting
section
Distance of signal :
About 20 ft. (6 m)
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
ON/OFF
(operate/stop) button
FAN speed control
WIDE VANE
VANE control
button
SMART SET
button
NATURAL
FLOW button
SENSOR
(i-see) button
CLOCK button--
N
Remote controller holder
• Install the remote con-
troller holder in a place t
where the signal can be I
received by the indoor I
unit. I
° When the remote con-
troller is not used, place I
it in this holder. /
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
INDIRECT/DIRECT
button
TIME, TIMER set buttons
Increase time
Decrease time
WEEKLY TIMER
set buttons
button
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
Only use the remote controller provid-
ed with the unit.
Do not use other remote controllers.
If two or more indoor units are installed
in proximity to one another, an indoor
unit that is not intended to be operated
may respond to the remote controller.
Installing the remote controller batteries
Press RESET. '_lv__
], Remove th "/_',_£_._ _'_
e_n__£_
__'% 2_ Insert the negative
P/k:li°feAAatle r ies first.
_1_ _, Install the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low. In
7 days after the indicator starts lights up, the remote controller stops working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
Setting current time
], Press CLOCK.
_CLOCK_ '_,'M
_g:uu
. Press CLOCK again. CLOCK
Press the DAY button
to set the day.
Press either the TIME button
or the TIMER buttons to set
the time.
PM Each press increases/decreas-
I-UU es the time by 1 minute (10
minutes when pressed longer).
Press CLOCK gently using a thin instrument.