Polar UA037 Manual De Instrucciones página 5

Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your POLAR product.
The ice maker is designed to make ice
cubes and should not be used as storage to
preserve foods, drinks, etc.
Pack Contents
The following is included:
• Ice Maker
• Ice scoop
• Inlet/Outlet hoses
• Sealing washers
• Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Note: Only use the hoses supplied with the
appliance. Other hoses are not suitable and
should not be used.
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. Remove the Scoop, Inlet/Outlet hoses and
Sealing Washers from the ice bin.
3. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
4. If necessary, adjust the screw legs of the ice
maker to make it level. The efficiency of the
ice maker can be reduced if the appliance is
unevenly located.
UA037_ML_A5_V1_20240118.indb 5 UA037_ML_A5_V1_20240118.indb 5
Installing the Drain
• Please note: this model drains via
gravity - no drain pump supplied. An
optional drain pump is required if
installing this unit lower than the drain
standpipe.
• Ensure the end of the drainage pipe is
situated lower than the Water Outlet
valve for efficient drainage.
5. Connect one end of the corrugated outlet
hose to the water outlet on the rear of the ice
maker.
6. Attach the other end of the hose to a plumbed-
in stand waste pipe or container suitable for
collecting waste water.
Installing the Cold Water Feed
Note: The highest temperature for the
water to be used: 38°C
7. Place the sealing washers on the water inlet at
the back of the ice maker and attach one end
of the inlet hose.
8. Connect the other end of the inlet hose to the
water supply.
EN
Water inlet
Drainage valve
cap
Water outlet
5
2024/1/18 14:38 2024/1/18 14:38