• Do not sweep up any hot objects.
• Watch out for other people while using
the device, particularly children.
• Watch out for pets while using the device.
• Wear gloves when emptying the collec-
tion container; there is a risk of being
cut by sharp objects (e.g. shards of
glass or metal).
Assembly
Assembling the device
Attaching the base to the lower
bar
1. Insert the lower bars (2) into the
appropriate recess inside the base (4).
The side of the lower bar with the
recess in the bore must be facing up.
2. Insert one screw (9) into each bore on
the lower bar and tighten them with a
washer (8) and a wing nut (7).
Attaching the base on the
housing
1. Place the base (4) in the recess (12) on
the housing (6).
2. Clip the base on the housing.
3. Insert the safety lock (10) into the two
bores on the housing in order to secure
the base in its position.
4. Proceed in the same manner with the
second base.
Attaching the handle
1. Place the handle (1) on the lower bar
(2) and fasten it with a screw (9),
washer (8) and wing nut (7), as shown.
Assembling the
collection container
1. Feed the two angled rods (13) through
the tabs of the collection container (3).
2. Loosen the two coupling nuts of the
connecting piece (11).
3. Insert the two free ends of the angled
rods into the connecting piece.
4. Tighten the coupling nuts of the
connecting piece.
5. Feed the straight rod (14) through the
tab of the collection container.
6. Loosen the two coupling nuts of the
connecting pieces (16).
7. Insert the two ends of the straight rods
(14) into one of the connecting pieces
(16) each.
8. Tighten the coupling nuts of the
connecting pieces (16).
9. Slide the grip bar (15) between the
tabs under the angled rods.
10. Clip the grip bar onto the angled rods.
Attaching the collection
container
1. Hold the collection container (3) at the
grip bar (
15).
2. Lower it onto the lower bars (2).
The two hooks have to be behind the
curvature inside the base; see the
detailed illustration
GB
IE
1
.
13