Publicidad
Idiomas disponibles
Idiomas disponibles
Kitchen-Aid grills:
Estimated Assembly Time: Approximately 10 minutes
Required Tools: Phillips Screwdriver (not included)
1.
To attach the universal bracket (G) to the motor
bracket (B), align the pre-drilled holes in both
brackets and secure together using two 2-in. bolts
(H) as shown in Fig. 1.
2.
Align the holes in the universal bracket (G) to the
pre-drilled holes on the left side of the grill. Attach
the universal bracket using two 1/4-inch screws
with flat washer/lock washers/nut (I) as shown in
Fig.2.
Note: The universal bracket may have to be
adjusted once the motor is attached and the spit rod
is inserted.
3.
Slide rotisserie motor (A) over motor bracket (B) as
shown in Fig. 3.
8
ROTISSERIE ASSEMBLY
Fig.1
Fig.2
Fig.3
4.
Place the meat forks (E) onto the spit rod (D) as
shown in Fig. 4.
Note: The rotisserie forks are sharp.
Fig.4
5.
Place the spit rod (D) into the motor (A), making
sure the rod aligns with the motor correctly as
shown in Fig. 5.
Fig.2
Fig.5
6.
Slide the shaft collar (F) onto the opposite end of
the spit rod and place into the slot on the right side
of the grill. The thumbscrew for the shaft should be
inside the grill firebox as shown in Fig 6
Fig.6
Publicidad
