Publicidad
Idiomas disponibles
Idiomas disponibles
EN
INTRODUCTION
Thank you for the purchase of our quality product. Used carefully and in accordance with the instructions
set out below.
Please read and keep these instructions for future reference.
ASSEMBLY INSTRUCTION
1. Turn the radiator upside-down on a scratch-
free and stable surface to prevent damage to the
paint finish or your floor surfacing(see Fig 1).
2. Fit the wheels assemblies onto the radiator by
placing the U-shaped bolts between the outer-
most fins on each side of the radiator (see Fig.2
- 3).
3. Securely fasten the wheels assemblies onto the
radiator by screwing the wing nuts onto the bolts
(see Fig. 4).
TIP-OVER PROTECTION
This heater is protected with a safety switch that
turns off the appliance automatically when the
heater falls over, or is at an excessive angle from
the horizontal. This helps prevent accidents, and
the heater will resume operation when it is put
back upright.
18 | www.garsaco.com
Remark: only for 5fins and 7fins model, fix the front
wheels assembly at the bottom of front panel by two
screws(see Fig 5), the other wheels assembly same
as point 2 and 3.
WARNING: Only operate the radiator in normal upri-
ght position with wheels assemblies attached to the
bottom (wheels on the bottom, controls on the top),
any other position could create a hazardous situation
If you are in any doubt about installing this product,
consult a qualified electrician.
Fig. 5: only for 7 fins.
OVERHEAT PROTECTION
This heater is protected with overheat protection that
switches off the appliance automatically in case of se-
vere overheating. In this case, unplug the appliance,
wait about 30 minutes for it to cool and remove any
possible cause of overheating, eg. something cove-
ring the heater. Check for damage to the appliance,
the cord and the plug. If there is no damage, plug the
unit back in and switch it on as described above. If
the heater still does not turn on, please contact Cus-
tomer Service for assistance.
Publicidad
