Nevadent NMD 3.7 D8 Instrucciones De Uso página 67

Fitting/removing attachments
Note
► Make certain that the handpiece
2
attachments
► The appliance comes with two attachments
rings for different users.
► If used daily, replace the attachments
► Use only the attachments
on ordering replacement attachments
replacement parts. The attachment nozzles of Panasonic
(nozzle model EW0950) can also be used for this appliance (*Panasonic is a
registered trademark of Panasonic Corporation).
♦ To fit an attachment
Press the attachment
♦ To remove an attachment
and pull the attachment
2
♦ Attachments
charging station
Before first use
1) Rinse the attachments
one of the holders
the handpiece
2) Pull the water tank
in clean water.
3) Push the water tank
pletely. Ensure that the intake tube is in the water tank
4) Fill the water tank
5) Point the nozzle
doing so, make sure that you do not tilt the handpiece
wise, the intake tube will no longer reach water or water could leak out of the air
supply openings
6) Press the On/Off button
discharging it via the nozzle
empty. This flushes all internal lines.
7) Press the On/Off button
│ GB │ MT
■ 64
5
.
2
recommended by the manufacturer. Information
2
to the handpiece
2
down until it completely engages in the attachment socket
2
from the handpiece
2
upwards off the handpiece
that are not in use can be placed in one of the holders
q
.
2
in clean water. One attachment
9
on the charging station
5
.
6
downwards off the handpiece
6
back onto the handpiece
6
as described in the section Filling the water tank.
1
of the attachment
4
.
u
. The handpiece
1
. Let the handpiece
u
to switch off the handpiece
is switched off before fitting or removing the
2
with different coloured marking
2
after no more than six months.
2
can be found in the section Ordering
©
5
, insert it into the attachment socket
5
, press the release button
5
.
2
q
. Fit the other attachment
5
and rinse the water tank
5
until it clicks into place com-
6
.
2
downwards into a washbasin. When
5
too far forwards. Other-
5
starts pumping water and
5
run until the water tank
* water jet flossers
3
3
i
9
on the
can be placed into
2
onto
6
6
5
.
NMD 3.7 D8
.
.
is