Wesco WS4366 Manual Original página 10

by keeping the tracking adjustment set properly.
7. DUST BAG (SEE FIG. F)
You must use the dust bag provided to collect the dust produced
during sanding. The dust bag's plastic bracket slides down onto the
dust extraction outlet on the belt sander. When the dust collection
bag is full, remove and empty by opening the zipper on the dust bag.
8. DRIVE BELT REPLACEMENT (SEE FIG. G, H)
WARNING! Remove the main plug from the socket
before carrying out a drive belt replacement.
Remove the two screws (a) and the belt cover as shown. (See Fig.
G)
Carefully cut the drive belt if not already broken and remove from
your belt sander. Fit your new drive belt around the large pulley.
Then install onto the small pulley by rotating clockwise and pushing
the drive belt shown around the small pulley at the same time. The
drive belt will be a tight fit. (See Fig. H)
Fit the belt cover and two screws (a).
TROUBLESHOOTING
1. If your sander will not operate, check the power at the mains
plug.
2. If the sander does not abrade surface, checking the sanding
belt. If the sanding belt has been worn, replace the new sanding
belt and try again. The sanding belt must be kept in a dry place.
3. If a fault cannot be rectified, return the sander to an authorized
dealer for repair.
WORKING HINTS FOR YOUR SANDER
If your power tool becomes too hot, especially when used at low
speed, set the speed to maximum and run with no load for 2-3
minutes to cool the motor. Avoid prolonged usage at very low
speed. Always use a sanding belt suited to the material you wish
to sand. Always ensure the work-piece is firmly held or clamped
to prevent movement. Support large panels close to the sanding
area. Any movement of the material may affect the quality of the
sanding finish. Start your sander before sanding and turn off only
after stopping sanding. For best results sand wood in the direction
of the grain. Do not start sanding without the sanding belt fitted.
Empty the dust bag every 5 minutes or sooner to ensure efficient
dust collection.
MAINTENANCE
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of
dust.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
10
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling
advice
PLUG REPLACEMENT (ONLY FOR
REWIRABLE PLUG OF UK & IRELAND)
If you need to replace the fitted plug then follow the instructions
below.
IMPORTANT
The wires in the mains lead are colored in accordance with the
following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of this appliance
may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows. The wire which is
colored blue must be connected to the terminal which is marked
with N. The wire which is colored brown must be connected to
the terminal which is marked with L.
WARNING!
Never connect live or neutral wires to the earth terminal of the
plug. Only fit an approved BS1363/A plug and the correct rated
rated current fuse which is used in the plug.
Note: If a moulded plug is fitted and has to be removed take
great care in disposing of the plug and severed cable, it must be
destroyed to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
clamped
Fuse
Brown L(live)
Cable grip
EN