Le Chai LB420X Instrucciones De Uso página 30

DEFROSTING
The defrosting of your wine cellar is fully automatic and takes place whenever the compressor stops. You
do not need to do anything.
During operation, condensation or ice drops may appear on the rear wall. These will be removed during
the automatic defrosting.
The water produced will flow out through the drain hole and be collected in the tray located on the
compressor from where it will evaporate.
Important: Keep the drain hole and gutter clean to avoid clogging and water flowing into the cabinet.
CLEANING
Before any cleaning, unplug the device from the mains.
Never use abrasives or a scraper sponge when cleaning the inside or the outside of your wine
cabinet.
Remove all accessories (racks, etc.). Wash them using lukewarm water to which has been added a

gentle unscented detergent (dish washing liquid for example); rinse with bleach water and carefully
dry off.
Wash the inside walls in the same way; pay particular attention to the rack supports

 Wash the door seal as well as under the seal.
Plug the wine cabinet into the mains.

From time to time, dust off the condenser behind the device; accumulated dust may reduce the efficiency
of your wine cabinet.
In the event of a prolonged absence, empty and clean out the device; maintain the door slightly open
during the period of non-use.
CHANGING DOOR OPENING SIDE
Due to its construction it is not possible to change the opening direction of the door.
REPLACING THE ILLUMINATING LAMP
The device uses light emitting diodes (LEDs). This type of diode cannot be changed by the user. The life
cycle of the LEDs is long enough so that they do not need to be changed. If however, in spite of the care
taken by the manufacturer, the LEDs do fail, please contact your Customer Care Service for any repair.
-This product contains a light source of energy efficiency class 'F'.
- The light source of this product may only be replaced by qualified personnel.
CARE OF YOUR CABINET
EN-30