Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE: STEAMING YOUR GARMENTS
Connect the power cord to compatible electrical outlet and press the power switch.
Once the power light is on, steamer will start to heat up. Allow 70 seconds for steam to
come out.
Hang garment against a heat and steam-proof surface.
Hold the fabric taut, and direct the flow of steam toward the garment to remove wrinkles in
an up and down motion.
The steamer should be used only in an upright position, slowly move the steamer up and
down in a vertical motion. Refrain from using the steamer in or on garments in a horizontal
or tilted position or left to right.
Hold steamer by its handle when using. Do not grasp body of unit while steaming garments
or while unit is hot.
Refrain from making any quick motions while steamer is on; quick motions could result in
hot water spitting.
Always empty the water tank after each use.
To clean the outside of the steamer, gently wipe down with a damp cloth.
Distilled or filtered water is recommended.
Do not fill the water tank with cleaning agents.
Always ensure the steam outlet vents are clean and free from buildup and debris.
If buildup occurs and steaming becomes intermittent, add a descaling solution of 1/2 distilled
water and 1/2 distilled vinegar to the water tank and turn on the steamer until solution is used.
Refill the tank with distilled or filtered water and allow it to steam through the unit before
steaming garments.
The steamer does not heat up
The steamer does not produce
steam
Water spills from the water tank
For more troubleshooting & steaming tips visit www.trueandtidy.com
CARE & CLEANING
TROUBLESHOOTING GUIDE
Check the main power source and electrical
circuit
Make sure there is enough water in the tank.
Make sure power switch is ON
Hold the steamer in an upright position
Make sure water is not over the MAX level.
If there is visible buildup in the water tank,
decalcify as instructed
Publicidad
