Publicidad
Idiomas disponibles
Idiomas disponibles
AUTO-OFF
Auto-Off Feature when the iron is plugged in, ON/OFF indicator light will
be red, indicating that there is power to the iron. If you leave the iron:
• in a horizontal position without moving it, or accidentally tip the iron
over, it will automatically stop heating after 30 seconds. The wait/ready
light will blink red to let you know that the iron has stopped heating.
• in a vertical position (on its heel rest) without moving it, the iron will
automatically turn off after 15 minutes. The wait/ready light will blink red
to let you know that the iron has stopped heating.
IMPORTANT: The wait/ready light will continue to blink red until the iron
is unplugged or reset. To reset the iron: Move the iron back and forth to
reset. The wait/ready light will change from blinking red to solid red and
the iron will start heating again.
WARNING: Auto-Off is a safety feature, not a recommended means
for turning your iron off. See "STORING THE IRON" for information on
turning off your iron and storing it safely between use.
-10-
MAINTENANCE AND CLEANING
Before cleaning the Iron, always make sure that it is disconnected from
the electrical wall socket and is completely cool.
SOLEPLATE
• Residue on the Soleplate can be wiped off with a cloth soaked in a
solution of water and vinegar.
• Do not use scouring pads, abrasives or chemical cleaning solvents as
they may damage the finish.
HOUSING
• The housing can be cleaned with a moist cloth and then wiped dry.
• Other than the recommended cleaning, no further user maintenance
should be necessary. If for any reason your Steam Iron should require
repairs, do not try to fix it yourself.
STORING THE IRON
1. Turn off the iron and disconnect the plug from the electrical wall
socket.
2. Set the Iron in an upright position and let it cool down completely.
3. Set the Steam Select Switch to the closed position
4. Empty out all the water remaining in the Water Reservoir by opening
the Water Reservoir Lid and inverting the Iron over the sink.
5. The Power Cord can be wound around the Heel Rest for easier and
tidy storing once the unit has cooled down. The Iron should always
be stored in an upright position.
.
-11-
Publicidad
