Ghibli 1 Serie Uso Y Mantenimiento página 51

4.1 CHARGING THE
BATTERY
DANGER:
Charge the batteries in rooms which are
well-ventilated and comply with applica-
ble regulations in the country of use.
For safety-related information, follow what
is described in chapter 1 of this manual.
WARNING:
For information and warnings about the
battery and on board battery charger (if
present) follow what is described in the
battery charger manual enclosed with
this document.
WARNING:
When the machine leaves the factory, it is
calibrated to operate with gel batteries. If
acid batteries are installed, it is necessary
to contact the Support Centre to carry out
new calibration.
It is forbidden to use the machine with gel
batteries if the machine is calibrated for
use with acid batteries.
N.B.:
For further information about calibration,
please refer to the information in paragraph
10.1.h.
N.B.:
10 hours are needed for complete battery
charging. Avoid partial recharges.
4.1.a - Charging the battery using the
on board battery charger (if
present) (Fig. 6)
- Move the machine close to a mains elec-
tricity socket.
- Remove the battery plug (1) from the sys-
tem socket (2).
- Connect the battery plug (1) to the on
board battery charger (4) socket (3).
- Extract the cable (5) from its special lodg-
ing and connect it to the socket on the
machine (6). Connect the other end of the
cable to an electrical outlet.
1
2
2
3
1
7
EN-11
4
5
EN
6
Fig. 6