Parrot Uncle F6366CH110V Instrucciones De Instalación Y Operación página 6

1.INSTALLING RECEIVER IN CEILING FAN
A. Safety precautions:
Do not use with solid state fans.
Electrical wire must meet all local and national
B. Electrical rating: 110/120V 50/60Hz
MAX. Motor watts: 45W
MAX. Light watts: 24W
Otherwise power can cause serious injury or death.
C. Installing receiver in fan:
a. Remove power from the circuit.
b. Remove ceiling fan canopy from the mounting
bracket.
c. Disconnect existing wiring between ceiling fan and
Supply in electrical junction box.
d. Make connections as follows, using the wire nuts
supplied:
(FIG . 1)
LIGHT
INPUT
OUTPUT
MOTOR
OUTPUT
ANT
(FIG.1)
Remote controller
GENERAL INFORMATION
electrical code requirements.
(FIG . 2)
Use wire connecting nuts supplied with the fan
FROM POWER SOURCE
WHITE
RED or BLACK
AC 110~120 VOLT 50/60Hz
CONNECT
CANOPY
Green fan wire ....Bare supply wire
Red receiver wire(AC IN L) ....
White receiver wire(AC IN N) ....White supply wire
White receiver wire(TO MOTOR 1) ....
Black receiver wire(TO MOTOR 2) ....Black fan wire
Red receiver wire(TO MOTOR3) ....Red fan wire
receiver wire(For light ) ....
Red
Yellow receiver wire(For light ) ....
White receiver wire(For light ) ....
Installation & Operating Instructions for the
Parrot uncle Owner's Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
ANTENNA PUT AT OUTSIDE
OF CANOPY BOX CAN GET
MORE OPERATION
DISTANCE
TO
supply wire
Red
White
1 Red light wire
2 Yellow light wire
3 White light wire
F6366CH110V
RECEIVER
CANOPY
(FIG.2)
fan wire