Basic Playback Operation; Listening With Headphones - Yamaha YHT-S401 Manual De Instrucciones

BASIC OPERATION
Once you have finished all cable connections and remote control operation, follow the procedure below to start basic
playback operation.
You can operate the unit by the TV's remote control
when the HDMI control function is available. See the
page 23 for details.
1
Press (Power).
This unit is turned on and the STATUS indicator
lights green.
The input source and surround mode appear in the
front panel display.
y
This unit has the auto-sleep function, which will
automatically switch the unit to turn off if the unit is left
turned on for 12 hours without any operation being
performed.
2
Press one of the input buttons to select an
input source.
After the input source name has been displayed in the
front panel display for three seconds, the front panel
display returns to its normal display. (Input source
name: surround/stereo mode).
10
En

Basic playback operation

3
1
4
2
4
5
Insert a headphone plug to the PHONES jack (☞ P. 3) of
this unit.
• The headphone volume, tone control can be set
• You can enjoy surround and stereo sound using a
Start playback on the selected external
component.
For information on the external component, refer to
the instruction manual for the product.
Press VOLUME +/– to adjust the volume
level.
Press SUBWOOFER +/– to adjust the
subwoofer level.
y
• To turn off the volume temporarily, press MUTE. While
the mute function is activated, the VOLUME indicator
flashes. To resume the volume, press MUTE again or
press VOLUME +/–.
• When audio is output from both TV speaker and this unit,
mute the TV sound.
• The subwoofer volume can be adjusted separately from
the volume.
• You can also adjust the subwoofer volume listening to test
tone. (☞ P. 19)
• Lowering the subwoofer volume is recommended at night.
Note
When sound of HDMI is output from the TV, the volume
level does not change if you press VOLUME +/– or MUTE
of the remote control.
Select surround mode or stereo mode and
set your sound preferences. (☞ P. 11)
Press (Power) again to set the unit to
standby mode.
When the HDMI control function is set to on or the battery of
iPod/iPhone is charged, the STATUS indicator lights red. When
the HDMI control function is set to off, the STATUS indicator
turns off. (☞ P. 3)

Listening with headphones

separately with speaker setting.
headphone same as the speaker. (☞ P. 11)