Publicidad
Idiomas disponibles
Idiomas disponibles
seat under the seat cover. Close the compartment (B, fig. 19).
8.
Unfasten the metal clasps located on the lower backrest cushion, then place all
the seat belt components in the space under the lower backrest cover.
9.
Lower the upper part of the backrest cover and fasten the metal clasps again.
REMOVING THE SEAT – ISOFIX
To detach the ISOFIX arms, push in the ISOFIX lever (14, fig. B). The arms will slide out
of the base. Then press the ISOFIX removal buttons (14a, fig B) on each side – the arms
will disengage. The indicator on the ISOFIX button will turn red. Press the ISOFIX lever
(14, fig B) again and retract the arms by sliding them into the seat base on one side.
REMOVING THE SEAT – TOP TETHER
Loosen the belt. Unbuckle the Top Tether belt from the anchor points in the car. The
indicator will turn red.
SEAT TILT ADJUSTMENT
To adjust the seat tilt, push the seat tilt adjustment lever (18, fig. B) and move the seat
to the desired position. A click signals the correct setting.
The seat has 5 levels of backrest tilt adjustment forward and rearward facing.
REMOVING AND ATTACHING THE COVER
The cover must be unzipped and slid completely off the seat body. To do this:
1.
Adjust the headrest to the highest available position (see: Headrest adjustment).
2.
Unbuckle the seat belts (see: Fastening and unfastening the seat belts).
3.
Unfasten and remove the seat belt protection cushions.
4.
Start the removal from the cover located on the headrest.
5.
Unfasten the metal clasps and then remove the rest of the cover.
To reinstall the cover on the seat, follow the above steps in reverse order.
CLEANING AND MAINTENANCE
The cover can be washed by hand at a maximum temperature of 30°C. Do not use
tumble dryers when drying. The cover should not be exposed to sunlight for drying.
Plastic parts can be cleaned with a damp cloth and mild detergent.
Note! Do not use strong detergents or bleaching agents.
‑ 17 ‑
EN
Publicidad
