Publicidad
Idiomas disponibles
Idiomas disponibles
3. Switch on the appliance and operate as usual.
4. Periodically press the battery charge level pushbutton to check battery status.
PORTABLE INFLATOR
The built-in 12 volt DC inflator is the ultimate inflator for all vehicle tires and recreational inflatables. Three
different sized nozzles are supplied. Each nozzle will clip on the end of the standard tire valve connector located
at the free end of the inflator hose. The inflator hose with tire fitting is stored in a retaining channel between the
jumper cable channels on the rear of the unit. The ON/OFF Switch is located on the top of the Main Unit.
The inflator may be used by removing the air hose from the storage hatch and if required, fitting an appropriate
nozzle to the air hose. An ON/OFF switch located on the top of the unit controls the power to the inflator and the
gauge light. Refer to the "Controls and Indicators" section on page 4 for location of inflator hose. Return hose
to the storage compartment after use.
WARNING: BURST HAZARD
• The inflator is capable of inflating up to 150 pounds per square inch (psi) pressure. To avoid over-inflation,
carefully follow instructions on articles to be inflated. Never exceed recommended pressures. Bursting articles
can cause serious injury.
• Always check pressure with the pressure gauge.
• Never leave the inflator unattended while in use.
CAUTION: RISK OF PROPERTY DAMAGE
Do not operate inflator continuously for extended periods of time (approximately 10 minutes, depending on
ambient temperatures), as it may overheat. In such event, inflator will automatically shut down. Immediately
turn OFF the Inflator Power Switch. Restart after a cooling down period of approximately 10 minutes.
Inflating
1. Locate the inflation valve on your product and open it.
2. Fasten the Inflator/Deflator Hose (stored in the accessory bag on the side of the unit) to the Inflator Port.
3. Attach the appropriate nozzle to the free end of the Inflator/Deflator Hose.
4. Slide the Air Compressor/OFF/Inflator Switch to Inflator (bottom position).
5. When product is fully inflated, turn the Air Compressor/OFF/Inflator Switch to OFF, remove hose from valve
and close the valve.
Deflating
1. Open the valve on your product completely to release air.
2. Fasten the Inflator/Deflator Hose (stored in the accessory bag on the side of the unit) to the Deflator Port.
3. Attach the appropriate nozzle to the free end of the Inflator/Deflator Hose.
4. Slide the Air Compressor/OFF/Inflator Switch to Inflator (bottom position).
5. When product is fully deflated, turn the Air Compressor/OFF/Inflator Switch to OFF, remove hose from valve
and close the valve.
CARE AND MAINTENANCE
Charging/Recharging
This product has a sealed lead acid battery that should be kept fully charged. Recharge before first use, immediately
after each use, and once a month if not used. Failure to do this may reduce the battery life dramatically. Refer to the
"Charging/Recharging" section of this Instruction Manual.
Fuse Replacement
Main Fuse
This unit is delivered with the main fuse installed in the main fuse slot on the control panel. If you suspect that
this fuse is "blown," refer to the "Service Information" section of this Instruction Manual for information on
obtaining a replacement.
12 Volt DC Charging Adapter
1. Remove plug from accessory outlet. Remove the gold cap by turning counterclockwise and lifting off.
2. Remove center pin and spring. Remove fuse.
3. Replace fuse with same type and size fuse (8 amp).
4. Replace center pin and spring inside plug.
5. Replace gold cap by turning clockwise.
6
Publicidad
