Descargar Imprimir esta página

Konig & Meyer AC 7001 SP 3 Instrucciones De Uso página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 9
Mounting
!There is a risk of crushing between the components during assembly!
1.) Unpack and check product for damage and completeness
2.) Assemble the base plate with base tube
Insert the required cable through the cable lead-through of the
base tube 1 and feed it through the base plate at the lower end.
Place the base tube on the base plate 2 and screw it in place
with the four pan head screws M5 x 25 mm 3. Ensure that the
four bars on the base tube are inserted into the recesses provi-
ded for this purpose in the base plate. The base tube must lie
flat on the base plate.
NOTE: When assembling, pay attention to the position of the
cable lead-through at the top end of the base tube. Once instal-
lation is complete, the cable lead-through should point to the
rear.
1x base tube
1x speaker holder
1x base plate
Accessory bag
1x Pan head screw M6 x 35 mm
4x Pan head screw M5 x 25 mm
3x Countersunk head screw
3xM4 × 10 mm
1x felt ring
1x Allen wrench 4 mm
1x Allen wrench 3 mm
1x Allen wrench 2.5 mm

Publicidad

loading