Craftsman 536.884581 Manual Del Propietário página 5

tk
/IkCAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower,
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton
The figure to the right shows the snow
thrower completely assembled°
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit.
TO REMOVE SNOW THROWER
FROM CARTON
• Locate and remove container of Crafts-
man 2-cycle oil,
• Remove the inserts positioned around the
unit and the packing material,
, Cut down all four corners of the carton
and lay the panels flat.
, Pull snow thrower out of the carton_
TO ASSEMBLE THE SNOW
THROWER
, Remove wrap on upper handle and along
the side of both handles, Discard wrap.
• Loosen the tee knobs on each side of the
upper handle. See figure on this page_
• Raise the upper handle to the operating
position as shown in figure. Hold upper
handle apart to prevent scratching lower
handle.
° Check to be sure the clutch cable is not
caught in the handle. Tighten the tee
knobs.
Auger Control Bar
Chute Control
Tee
Chute Deflector
Knob
i/' CHECKLIST
Before you operate your new snow thrower,
to ensure that you receive the best perfor-
mance and satisfaction from this quality
product, p_ease review the following
checklist:
,f All assembly instructions have been
completed.
#' The discharge chute rotates freely.
4' No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the following
important items:
,Z,I Make sure gas tank is filled with the
correct mixture of gasoline and oil.
,/'4" Become familiar with a!l controls-their
location and function. Operate controls
before starting engine.