Craftsman 247.203703 Manual Del Operador página 10

3. Place the steering wheel cap over the center of the steering wheel and
push downward until it "clicks" into place.
Attaching The Seat
If the seat for your tractor was not attached at the factory, refer to the following
steps.
NOTE: For shipping reasons, seats are either fastened to the tractor seat's pivot
bracket with a plastic tie, or mounted backward to the pivot bracket. In either case,
free the seat from its shipping position and remove the adjustment knob from the
bottom of seat before proceeding with the instructions below.
1. As already instructed, remove the seat adjustment knob installed by the
factory in the bottom of the seat. See "a" in Figure 4.
a
b
2. Align the seat over the seat pivot bracket as shown in Figure 4 and fit the
seat onto the pivot bracket inserting the two tabs on the seat bottom into
the slots on the pivot bracket.
ASSEMBLY
Figure 3
Figure 4
3. Slide the seat rearward in the seat pivot bracket (c), lining up the center
rear slot in the pivot bracket with the remaining hole in the seat's base. See
Figure 5.
Note: Be certain the two seat tabs engauge the pivot bracket as shown in
the bottom inset of Figure 5.
d
4. Select desired position for the seat, and secure with the adjustment knob
removed earlier (d in Figure 5).
5. To adjust the position of the seat, remove the adjustment knob on the
bottom of the seat. Slide the seat forward or backward as desired. Reinstall
the adjustment knob. See Figure 5.
Tire Pressure
Maximum tire pressure under any circumstances is 30 psi. Equal tire pressure
should be maintained at all times. Never exceed the maximum inflation
pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
• Approximately 10 psi for the rear tires
• Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire
pressure could cause the cutting deck to mow unevenly.
10
c
Figure 5
WARNING