KREA Swiss oilSPRAY Manual De Instrucciones página 5

• Maintain a constant distance and smooth movement.
• Avoid shaking the gun or sharp movements as this will cause droplets.
• Varying the speed of arm movement, the height and number of coatings, will
vary the effect and thickness of sprayed material.
• It is recommended to start and stop the sideways movement off the product
and only press the power button when over the product. This helps reduce the
volume being sprayer at the turning point.
• The supplied R6 round nozzle is the most suitable "all round" nozzle. Generally
using a smaller (R4) or larger (R8) holed nozzle can improve the results for
thinner or thicker materials, respectively.
• If you want to spray from below, you may rotate the nozzle extension -
however - only rotate in a clockwise direction (when viewed from the front),
otherwise you will loosen the nozzle extension. The easiest method of adjusting
the nozzle direction is from the right side, hold the pump housing firmly with
your left hand and move the nozzle extension with your right hand.
Spraying other materials?
The sprayer is only designed to spray oils of around 18 to 36 DIN/sec. Spraying
other materials is likely to produce a different effect. A simple way to reduce the
viscosity of food materials is to heat gently via a microwave or water unit, e.g.
heating 550 ml of thick butter fat with a viscosity of circa 65 DIN for 20 seconds
in a standard microwave can reduce the viscosity to circa 30 DIN/sec without
significantly impacting it`s usability.
4. CLEANING
IMPORTANT: Always remove the electric parts before washing the gun. These
parts should never be exposed to liquids. Always clean immediately after use.
For external cleaning, simply wipe down the outside of the sprayer with a dish
soap. For internal cleaning, we recommend to spray half a container of very hot
water through and then clean the individual parts using a suitable dishwashing
detergent. Careful use of a soft pipe cleaning brush is also recommended. Care
should be taken not to damage the cylinder by using abrasive or sharp tools. If
available, blowing air through the nozzle can ease the cleaning process. Rinse
thoroughly thereafter with hot clean water .
The sprayer is designed with quality components. If you experience any issue, we
recommend first following the trouble shooting document and film available on
our website: www.kreaswiss.com.
In most cases a part has been forgotten or the product needs a thorough cleaning.
If your issue persists, please contact your reseller for additional support.
Please always include the article number (page 28) in any correspondence.
5