KREA Swiss oilSPRAY Manual De Instrucciones página 6

DISMANTLING AND ASSEMBLING (see page 28-29)
• Remove the round jet nozzle (9) and then unscrew the bent nozzle extension
screw (8) from the pump housing (5).
• Remove the atomiser insert (7) and valve ball (6) from inside the chamber . Place
all parts in a small dish and clean them following the cleaning steps outlined
earlier . The suction tube (10) and container (11) can be washed in the sink.
• Remove the service screw (2) and take off the pump housing (5). Put the piston
(3), piston spring (4), hood (1) to one side and wipe them down as outlined
above.
• Remove the valve ball (6) from the pump housing (5) by using a copper or brass
pin to push it through the piston aperture.
• To assemble the gun, do so in reverse order . The piston should move freely in the
pump housing. Ensure the service screw, nozzle extension and round jet nozzle
pieces are all screwed on tightly.
6