Descargar Imprimir esta página

Weber Summit S 650 Guia Del Propietario página 10

Barbacoa de gas propano licuado
Ocultar thumbs Ver también para Summit S 650:

Publicidad

Idiomas disponibles

Idiomas disponibles

TO CONNECT THE HOSE TO THE CYLINDER:
1)
Locate hose retention clip (a) on regulator
hose. Secure into slot (b) on underside
of tank scale.
z_ WARNING: The hose must be secured
to the tank scale
with the Hose Retention
Clip. Failure to do so could cause
damage to the hose resulting
in a fire or explosion
which
can cause serious
bodily injury or death, and damage to
property.
Some LP tanks have differing top collar assembles.
(The top collar is the metal
protective ring around the valve.) One series of tanks mount with the valve facing
front (a). The other tanks mount with the valve facing away from the fuel scale
(b). Weber recommends
the use of cylinder manufacturer's
Manchester
and
Worthington,
with a 47.6 Ib water capacity. Other cylinders
may be acceptable
for
use with the appliance
provided they are compatible
with the appliance
retention
means (see illustrations).
(a)
The LP cylinder
is installed inside the base cabinet, on the tank
scale (right side).
2)
Open base cabinet doors.
3)
Turn the LP cylinder so the opening of the valve is either to
the front, side or rear of the Weber _ gas barbecue.
Lift and
hook the cylinder onto the fuel gauge.
4)
Lift tank up into position on the tank scale.
5)
Loosen the cylinder
lock wing nut. Swing the cylinder
lock
down. Tighten the wing nut.
TO CONNECT THE HOSE TO THE CYLINDER:
6)
Remove the plastic dust cover from the valve.
7)
Screw the regulator coupling onto the tank valve,
clockwise,
or to the right. Hand-tighten
only.
Note: This connection
tightens clockwise
and will not allow gas
to flow unless the connection
is tight. The connection
requires
tightening
by hand only.
WARNING:
Do not use a wrench to tighten
the connection.
Using a wrench could
damage the regulator
coupling and could
cause a leak.
You will need: LP cylinder, a soap and water solution
and a rag or brush to apply it.
8)
Mix soap and water.
9)
Turn on the cylinder valve.
10)
Check for leaks by wetting the fitting with the soap and water solution and
watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
if there is a leak, turn off the gas and tighten
the fitting.
Turn the gas back on and
recheck with the soap and water solution.
if leak does not stop do not use the barbecue.
Contact
the customer
service
representative
in your area using
the contact
information
on our web site. Log
onto
www.weber.com
®.
11)
When leak checking
is complete,
turn gas supply off at the source and rinse
connections
with water.
=
,
i i
i

Publicidad

loading

Este manual también es adecuado para:

Summit s 620Summit e 650Summit e 62089173