Descargar Imprimir esta página

Weber Summit S 650 Guia Del Propietario página 25

Barbacoa de gas propano licuado
Ocultar thumbs Ver también para Summit S 650:

Publicidad

Idiomas disponibles

Idiomas disponibles

LIGHTING THE ROTISSERIE
BURNER
ROTISSERIE BURNER SNAP IGNITION
Note: Each control knob snap igniter creates
a spark from the igniter electrode
to the
burner fighting tube. You generate
the energy for the spark by pushing in the control
knob and turning to "START/Hi".
This wi// ignite each individual
burner.
ATTENTION:
READ BEFORE
LIGHTING ROTISSERIE
BURNER
After a period of non-use, before lighting the Rotisserie
Burner, a few seconds
must pass for the gas supply
line to
fill.
When using the snap igniter you will see a flash of flames
moving from left to right across the Rotisserie
Burner
surface,
the Rotisserie Burner is not lit until the entire
ceramic
surface
is aflame.
At this point, start a count of 20 seconds
before releasing
the
Rotisserie
Burner control
knob.
The Rotisserie
Burner surface will glow red once the burner
is fully ignited.
*The grill illustrated
may have slight
differences
than the model purchased.
)
DANGER
Failure to open the lid while igniting the grill, or not waiting
5 minutes to allow the gas to clear if the grill does not light,
may result in an explosive flare=up which can cause serious
bodily injury or death.
CAUTION:
The Rotisserie Burner flame may be difficult to
see on a bright sunny day.
WARNING:
Check hose before each use of grill for nicks,
cracking,
abrasions
or cuts. if the hose is found to be
damaged in any way, do not use the grill. Replace using
only a Weber _ authorized
replacement
hose. Contact
the
Customer
Service Representative
in your area using the
contact
information on our web site.
Log onto www.weber.com
®.
1)
Open the lid.
2)
Remove the warming
rack and the cooking grates from the cookbox.
3)
Make sure all burner control knobs are turned off. (Push control knob in and turn
clockwise
to ensure that it is in the "OFF" position.)
WARNING:
The burner control
knobs must be in the "OFF"
position before turning
on the liquid propane cylinder
tank
valve. If they are not in the "OFF" position, when you turn on
the LP cylinder
vane,
the "excess gas flow control"
feature
will activate,
limiting
the flow of gas from the LP cylinder,
if
this should
occur, turn off the LP cylinder
valve and burner
control
knobs. Then start over.
DANGER
When the "excess
gas flow control"
feature is activated,
a small amount of gas is still flowing
to the burners.
After
turning
off the cylinder
and burner control
knobs, wait at
least 5 minutes for the gas to clear before attempting
to light
the grill. Failure to do so may result in an explosive flare=up,
which can cause serious
bodily injury or death.
®
®
®,
4)
Turn the cylinder on by turning the cylinder valve counter-clockwise.
Z_ WARNING:
Do not lean over the open grill.
5)
Push the control knob in and turn to "START/HI".
This action will spark the
igniter and light the Rotisserie
Burner. Continue to use the snap igniter until the
Rotisserie
Burner has ignited. Release the control knob.
6)
Check that the burner is lit by looking for the rotisserie burner to glow red.
WARNING: If the rotisserie
burner does not light, turn the
burner control
knob to "OFF" and wait 5 minutes to let the
gas clear before you try again or try to light with a match.
Note: When using the rotisserie with the lid closed, only fight two of the main burners
on each
side of the food (See Grilling Methods-indirect
Cooking).
Check your food
periodicafly
to prevent over cooking
on the outside. Turn off the rotisserie
burner once
the food has browned
to the desired
co/or. Finish cooking
on indirect
heat.
TO EXTINGUISH
Push in and turn each burner control knob clockwise
to "OFF" position. Turn gas supply
off at the source.

Publicidad

loading

Este manual también es adecuado para:

Summit s 620Summit e 650Summit e 62089173