Weber Summit S 650 Guia Del Propietario página 27

PROBLEM CHECK CURE
Rotisserie burner does not light. Did you hold the burner control knob in and Try to relight burner by holding burner control knob in and continue holding in until
hold in for 20 seconds until after burner 20 seconds after burner has ignited.
ignited?
Did you wait to see the entire ceramic surface When relighting burner by holding burner control knob in, wait to see the entire
become alight before counting 20 seconds? ceramic surface become alight before counting 20 seconds?
Did you repeatedly use the snap ignition until After waiting five minutes for gas to clear, try repeatedly using the snap igniter until
the burner ignited? the burner ignites (refer to "Lighting the Rotisserie Burner").
Does the igniter work (Do you see a spark Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
when you repeatedly use the snap igniter? customer service.
General Symptoms: The excess flow safety device, which is part of To reset the excess flow safety device turn all burner control knobs and the cylinder
Burner does not light. -or- Burner has the barbecue to cylinder connection, may have valve to "OFF". Disconnect the regulator from the cylinder. Turn burner control
a small flickering flame activated, knobs to "START/HI". Wait at least 1 minute. Turn burner control knobs to "OFF".
Reconnect the regulator to the cylinder. Turn cylinder valve on slowly. Refer to
"Lighting Instructions".
if problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com ®.
OPERATING THE HANDLE LIGHT
PROBLEM
The Weber Grill Out
TM
Handle Light has a built-in "Tilt Sensor." With the power button (a)
activated, the light will come on when the grill lid is open. The light will turn off when the lid
is closed. For daytime use, deactivate the sensor by pressing power button (a).
CHECK CURE
Replace batteries.
See assembly illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly illustration).
Weber Grill Out
TM
Handle Are the batteries old?
Light does not light.
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out
TM
Handle Light activated?
Is the Weber Grill Out
TM
Handle Light positioned correctly on the handle?
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
PROBLEM
Side Burner does not light.
CHECK
Is gas supply off?
The excess flow safety device, which is part
of the barbecue to cylinder connection, may
have activated.
CURE
Turn supply on.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
START/HI. Wait at least 1 minute. Turn burner control knobs to "OFF". Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting
Instructions".
Flame is low in "HI" position. Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? If match lights burner, check igniter (see Sideburner Maintenance).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com ®.