Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
• The extracted air flow must be clean (or rather free of grease, soot, chemical and corrosive substances or
explosive and flammable mixtures).
• Never cover the device intake and return to ensure optimal air passage.
• Make sure that the power supply voltage of the mains, the frequency, the number of phases and the nominal
power supply comply with the unit label data.
• The unit must be equipped with a three-pole switch.
• Make sure that the regulations and practices regarding the place of installation and use of this equipment
are complied with.
• Do not install this unit where it may be subject to splashing water .
• When the unit is used to manage moist air, a condensate collection and discharge system must be
incorporated in the exhaust pipe to ensure safe and healthy operation in compliance with regulations.
• DO NOT use this unit where there is, excessive dust, or an air rich in fibre, oil grease are present
• Be sure not to damage hidden electrical cables when installing the unit.
• The exhaust air must be released to the outside.
• The motors are equipped with watertight bearings and therefore do not need lubrication.
Compliance
The device may be used by children over 8 years old and persons
•
with reduced physical, sensory or mental capabilities, or lacking in
experience or necessary knowledge, as long as they are
supervised, or after they have received instructions for the safe use
of the device and on inherent dangers.
Children must not play with the unit.
•
Precautions must be taken to prevent the backflow of gas from the
•
gas exhaust pipe or other fuel-burning appliances into the room.
The installation of the flush-mounted box for the remote display
•
must only be carried out by professionally qualified personnel.
In case of damage to the power cable, have a BAXI Assistance Centre
•
replace it immediately.
Internal cleaning of the product must only be carried out by qualified
•
personnel.
The electrical system to which the product is connected must
•
comply with regulations in place.
The unit must be installed by professionally qualified personnel
•
only.
An omnipolar switch is required for installation, with a contact
•
opening distance that is equal to or greater than 3 mm, which allows
for complete disconnection under overvoltage category III
conditions.
Products equipped with single-phase wiring (M) engines ALWAYS
•
require connection to 220-240V (or only 230V where required)
single-phase lines. Any kind of modification shall be considered as
product tampering and shall nullify the relative warranty.
64
Publicidad
