Publicidad
Idiomas disponibles
Idiomas disponibles
DO NOT leave the PFL installed in environments which could cause damage or deterioration to the product. Refer to
l
the care details in Section
Examinations.
Instructions shall be retained and provided to all users of PFLs in the language of the destination country, even when
l
resold.
DO NOT exceed the maximum fall arrest forces as specified by governing standards or subsystem components.
l
Dual-connections shall only be made for the purposes of 100% tie-off transitions, if a dual connection is made for any
l
other purpose, anchorages of different elevations must be utilized.
Use of combinations of components or subsystems, or both, may affect or interfere with the safe function of the
l
components or subsystems.
Inspection/Removing Product From Service
PFLs that have arrested a fall or are unable to pass an inspection shall be tagged "UNUSABLE" and disposed of in
l
accordance with local regulations.
Due to the nature of some fall arrest events, it is possible for the energy absorber to not deploy. In the event that a
l
PFL is subjected to fall arrest forces and the energy absorber does not deploy, the PFL still must be removed from
service and marked as "UNUSABLE" until it has been destroyed.
If the load indicator is deployed, immediately remove the PFL from service and mark it as "UNUSABLE" until it has
l
been destroyed.
Failure to follow these warnings can result in serious personal injury or death.
3
Product Specification
System Requirements
Component
Anchorage Connector Standard
Harness Standard
Connectors Standard
Retractable Type Fall Arresters
Structure Strength
NOTE: The product may comply with standards shown. See product label for specific compliance information. Those
designated with a certification mark are listed with the corresponding agency as compliant to the applicable standard.
US
8 Cleaning and Storage
and inspection details in Section
ANSI/OSHA
ANSI Z359.18/
OSHA 1926.502, 1910.140
ANSI Z359.11/
OSHA 1926.502, 1910.140
ANSI Z359.12/
OSHA 1926.502, 1910.140
ANSI Z359.14-2021/
OSHA 1926.502, 1910.140
3600 lbs (16 kN) certified
5000 lbs (22.2 kN) non-certified
V-TEC® PFL
3 Product Specification
7 Pre-Use Checks and Periodic
CSA
CSA Z259.15
CSA Z259.10
CSA Z259.12
CSA Z259.2.2-17
5000 lbs (22.5 kN)
8
Publicidad
