Kerbl FastHeat 14150 Instrucciones De Uso página 10

DE FastHeat – Calf Milk Warmer with
EN
Convection Heating
1. General Notes
These operating and safety instructions are intended for the user. Please read the instructions carefully and adhere to the
regulations and notes before operating the device.
2. Purpose / Correct Usage
The calf milk warmer is designed for the warming of milk and feed that has been prepared with water. The calf milk
warmer may not be used for other purposes, specifically the prevention of the freezing of water in feed troughs and the
warming of aggressive liquids.
3. Safety Notes
CAUTION!
Hot surfaces and defective connection cables.
Risk of burns, electrical shock, fires and short circuits.
Risk of physical injury and material damage if used incorrectly.
• Do not place device on objects or surfaces that are sensitive to heat.
• The surface of the radiator will still be hot when the device is switched off.
Do not touch the radiator or place it on heat-sensitive surfaces.
• Ensure that the container for the liquid to be heated is made from a heat-resistant material.
• Only operate the device in the liquids it is intended for.
• Do not allow access lines to come into contact with hot surfaces, heat, oil or sharp edges.
• Do not pull on the access line to unplug or transport the device. Hang up the access line on the integrated
cable holder (5) when the device is not in use.
• Do not exceed the maximum immersion depth. ('max' position, (8) )
• Do not fall below the minimum immersion depth. ('min' position, (9) )
• Ensure that the device is only used by people who have the professional skills required to do so.
• Ensure that the voltage specified on the type plate matches the voltage of your power source.
• The device may only be connected to mains sockets which are isolated separately via a 30 mA circuit breaker (FI).
• Do not use any multiple sockets. This is a very powerful high performance device.
• Before each use, check that the device and the power cable in particular are in good condition. Do not operate
the device if a component is defective.
• Never operate the device unattended.
• Always keep the device in a safe, dry place out of the reach of children.
• Never remove the device type plate and replace it where necessary.
• National and international safety, health and occupational safety regulations must be observed and complied with.
• The handle section and access line should not come into contact with the liquid being heated.
• This device meets protection class IPX7.
• The device must not be completely submerged.
• When the device is switched on, the liquid to be heated must not be touched.
• Disconnect the device from the power supply before removing from the liquid being heated.
• This device may be used by people with impaired physical, sensory or mental abilities or those with insufficient experi-
ence and knowledge if they are being supervised or have been trained on the safe use of the device and understand
the underlying hazards. Children should not use this device. Cleaning and maintenance performed by the user should
not be carried out by children.
• Do not operate the device near explosive substances or atmospheres at risk of explosion.
• Regularly check the device for leaks (seals, cable conduits and screw attachments). Neglecting this check
can result in significant danger.
10