Installation - S&P EMIBLUE-A Serie Instrucciones De Uso

- Do not use the radiator to dry clothes as it is a fire-hazard.
- Do not handle the appliance with wet hands.
- When you clean it always take the precaution of disconnecting the
appliance.
- It must be installed by a technical electrician.
- This appliance is not suitable for use by persons (including children)
whose physical, sensorial or mental capacities are impaired, or who lack
the appropriate experience and knowledge necessary for its use, unless
acting under the supervision or instructions of a person responsible for
their safety.
- Children should be kept under supervision to ensure they do not play
with the appliance.
IMPORTANT: THESE APPLIANCES MUST BE PROPERLY EARTHED.
- In case of fixed connection, a device between the appliance and the main
supply should be placed to guarantee the disconnection with an opening dis-
tance of the contacts that permits the complete disconnection in the category
III of overtension conditions, according to the installation regulation.
- When installing the radiator, make sure that the connection cable can
never be in contact with a hot area of the appliance.
- If the supply cable is damaged it must be replaced by one of our service
centres or by people similarly qualified in order to avoid any danger.
- This appliance has been filled with a precisely determined amount of
special oil. If leaks appear, only our official repair service engineers can
mend them.
- When scrapping the heater, follow the regulations concerning the dispo-
sal of oil.

3. INSTALLATION

These radiators are for fixed installation and in order to install them follow
the instructions below:
Location
The radiator must be located as close as possible to exterior walls; the
thermal emission efficiency is shown in the graphic design RADIATOR
PLACEMENT (Fig. 1 – 5).
In bathrooms, the radiators must be installed beyond the prohibited and
protection limits (Fig. 6)
Wall installation
The radiator is fixed to the wall by 2 specially designed supports, using the
PVC rawl-plugs and the screws which are enclosed in the packaging. You
14