Hair Dryer - SEVERIN HT-6230 Instrucciones De Uso

Dear Customer
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
Th e hair dryer should only be connected to
an earthed socket installed in accordance
with the regulations.
Make sure that the supply voltage corresponds
with the voltage marked on the rating label of
the hair dryer.
Models with dual-voltage selector:
Models equipped with a dual voltage switch
can be set to diff erent supply voltages by
using a coin or a similar object. Make sure
that the set voltage corresponds with the
supply voltage.
Th is product complies with all binding CE
labelling directives.
Important safety instructions
Caution: do not use the
appliance near bath tubs,
washbasins or any other
receptacle containing water.
Protect the appliance from moisture and
splashing water and do not operate it with
wet hands.
In the vicinity of any water source, there
is a risk even when the appliance is
switched off . Th erefore, always remove
the plug from the wall socket aft er use,
especially if the appliance is being used in
a bathroom.
Additional protection is available by fi tting
an earth-leakage circuit-breaker with
a rated tripping current not exceeding
30mA into your bathroom installation.
Please consult a qualifi ed electrician.
Electric heating appliances operate at very
high temperatures. Do not touch any part
of the appliance except the grip. Otherwise
there is a real risk of burning.
Do not use the appliance on synthetic hair-

Hair dryer

5
pieces or wigs, as the heat emitted might
cause damage to the synthetic fi bres.
Make sure the air intake and outlet
openings are not blocked (e.g. by fi ngers or
hair), and that no fl uff or fi bre particles are
allowed to accumulate in the air intake.
A blockage in the air-fl ow system may
cause the integral thermal safety cut-
out to switch off the appliance. Should
this occur, immediately disconnect the
appliance from the mains power and allow
suffi cient time for it to cool down before
the blockage is removed and the appliance
is switched on again.
Every time the appliance is used, the main
body including the power cord as well as
any attachment fi tted should be checked
thoroughly for any defects. Should the
appliance, for instance, have been dropped
onto a hard surface, it must no longer be
used: even invisible damage may have
adverse eff ects on the operational safety of
the appliance.
To prevent damage to the power cord,
- do not bend or kink the cable, especially
where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
Do not leave the appliance unattended
while in use.
Always switch off and remove the plug
from the wall socket aft er use, as well as
- in cases of malfunction, and
- during cleaning.
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
Do not place the appliance on any surfaces
sensitive to heat during or immediately
aft er use.
Th is appliance is not intended for use
by any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning
the use of the appliance by a person