Making Ice; Cleaning, Care & Maintenance - Polar T316 Manual De Instrucciones

For Cleaning and maintenance
(GL192 only): you can remove
the cap on the sump drain to
drain all of the water from the
machine when the power is off.
Operation

Making Ice

Note: Before using for the
first time (or after a period of
inactivity), clean the water tank,
ice basket and ice basket shelf.
Use the first ice making cycle to
flush out the system.
Discard the water and ice
created from the first cycle.
T316_GL192_ML_A5_v8_20200907.indb 5 T316_GL192_ML_A5_v8_20200907.indb 5
1. Ensure the door is closed fully before use.
2. Press the Power switch to the On position [I].
The RUN light illuminates and the appliance
begins the ice making process. Each ice making
Water inlet
cycle takes approximately 25 minutes.
Drainage valve
3. When the cubes reach the ice sensor ice
cap
production stops. Production resumes once ice
has been removed from the bin.
Water outlet
4. Press the Power switch to the Off position [O]
at any time to halt the ice making process.
Model: T316
Drainage valve
cap
Cleaning, Care &
Water inlet
Maintenance
Water outlet
(attach the drain
• Always switch off and disconnect the power
hose here)
supply before cleaning.
• Warm, soapy water is recommended for
cleaning. Cleaning agents may leave harmful
Sump drain
residues. DO NOT wash the base unit, instead
wipe the exterior with a damp cloth.
• A POLAR agent or qualified technician should
Model: GL192
carry out repairs if required.
• Clean the water filter regularly with a small
brush, particularly in hard water areas. The
water filter is located just inside the water inlet
at the back of the appliance.
• If the Ice Maker is to be left unused for longer
than 24 hours, loosen the drain valve cap and
drain the water from the tank.
• The inner removable parts and water tank
should be cleaned regularly.
Note: Ensure metal rack is
pushed as far forward as
possible against plastic ice
curtain to allow ice to fall.
Filter for the drain system (for
GL192 only): Check the filter
monthly and clean if required.
Ensure the filter is repositioned
correctly after cleaning.
UK
5
2020/9/7 14:47 2020/9/7 14:47