Installation - Electrolux DF36A Manual De Instrucciones

Installation

1 - Remove the package base
Two people are required to remove the package base.
Carefully tilt the refrigerator for one side and breaks the side of the base
to remove it.
Tilt the refrigerator again to the other side and remove the rest of the base.
Remove the compressor pad which is the back of the refrigerator and all
foams and adhesive tapes of shelves and/or drawers.
2 – Choose the installation place
Respect the minimum distances between the refrigerator and the walls:
on top: 15 cm / side: 10 cm / back 15 cm.
Do not install the refrigerator outdoors or under the direct incidence of
sunlight.
Avoid placing the refrigerator next to chemicals or heat sources (stoves,
ovens, etc.), and areas with frequent water handling (tank, sink).
3 – Level the refrigerator
Level your appliance with door closed.
1. Start leveling the left side of the appliance and then level the right side.
2. Adjust the leveling leg until all rest firmly on the floor.
Avoid the refrigerator be tilted to one side or forward.
The only inclination allowed is back, to facilitate the doors closing.
After leveling your refrigerator, turn the stabilizer/leveling leg to touch the floor.
The function of this is to stabilize and level the product when the door is open
and loaded.
Whenever moving the refrigerator, it's necessary repeat the leveling process.
Leveling is important because it prevents swinging movements, vibration and problems with your
refrigerator.
Do not use different leveling legs from the original ones.
26