Cleaning And Maintenance - Electrolux DF36A Manual De Instrucciones

Unplug
before performing this
operation.
Never
refrigerator with cleaning
agents such as alcohol,
kerosene, gasoline, bleach, solvents,
acids, vinegar, abrasive or other chemicals
not recommended in this manual.
Always unplug the refrigerator before
performing this operation, taking care not
to touch the condenser and compressor;
they can be hot.
Do not pour water directly into or out of
the refrigerator.
Inside cleaning
Before you start cleaning the refrigerator,
remember that damp objects can easily
adhere to extremely cold surfaces, for
example, the inner surface of the freezer. Do
not touch the cold surfaces with wet hands,
cloths or sponges.
To clean the innner parts of the refrigerator, use
only a cloth moistened with a solution of water
and sodium bicarbonate (dilute 1 tablespoon
of bicarbonate for 1 liter of water).
Never use metal scrapers, sharp objects,
brushes, abrasive or alkaline cleaners to
cleaning of plastic surfaces inside your
refrigerator.
Outside cleaning
To easily clean the outside of your refrigerator,
use a solution of warm water with mild soap
and then dry it thoroughly with a clean cloth.
Every six months clean the condenser on
the back of the refrigerator using a vacuum
cleaner or a feather duster.

Cleaning and maintenance

the
clean
Accumulated
plug
operation of the condenser, affecting the
performance of the refrigerator and leading
to a higher energy consumption.
your
Cleaning the door seals
Clean the seals carefully with a soft, damp
cloth. The seals are not removable. After
cleaning, dry them being careful not to
damage them.
Water collector
Your refrigerator has a water collector located
on its back. Its function is to eliminate water
from the automatic defrost by evaporation.
The cleaning of the collector is not necessary
for the operation of the refrigerator. Avoid
contact with this refrigerator area.
LED lamp replacement
To replace the lamp of your refrigerator, proceed as
follows:
1. Turn the refrigerator off by unplugging the power cord
plug from the outlet.
2. Open the lamp cover by
pressing a side and pulling the
other side forward (A).
3. Replace the burnt lamp for
another of the same size,
maximum voltage and power
of 1,6 W. This lamp can be
purchased at the Technical
Service.
4. Replace the lamp, first fitting the
upper pins of the plastic cover
(B) and then push the bottom
end (A) against the refrigerator
bottom part until it locks into its
original position.
5. Connect the power cord plug
into the outlet.
dust avoids the
A
B
B
correct
A
31