Publicidad
Idiomas disponibles
Idiomas disponibles
HOW
TO CHECK
AND
ADJUST
THE
CABLES
The cables are adjusted at the factory
and no adjustment should be neces-
sary. If the cables have become
stretched or are sagging an adjustment
will be necessary.
Whenever belts are adjusted or re-
placed, the cables will need to be ad-
justed.
To check for correct adjustment, un-
hook "Z" fitting at clutch lever (see
Figure 42).
1. Move clutch lever to the full forward
position (just contacting
plastic
bumper).
Holding cable tight, note
position of fitting to hole in clutch le-
ver.
"Z" Fitting
Figure 42
2. The center of the "Z" fitting should
be between the center and top of
the hole in the clutch lever. Adjust
either the auger drive cable or the
traction drive cable as necessary
according to the following instruc-
tions.
Auger Drive Cable Adjustment
1. Run the engine until the fuel tank is
empty and the engine stops.
2. Stand the snow thrower up on the
front end of the auger housing.
3. Push cable through spring to ex-
pose the threaded portion of the
cable (see Figure 43).
Square
f_
End _ble
Spring
Locknut
Figure 43
4. Hold square end of threaded portion
with pliers and adjust Iocknut in or
out until correct adjustment is
reached. Pull cable back through
spring and connect cable.
F-O31068L
30
Publicidad
