Emergency Drain; Frost Precautions; Troubleshooting - AEG L 75480 WD Manual De Instrucciones

28 www.aeg.com
9.
1

14.8 Emergency drain

Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (9) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1. When you drain the water with the
emergency drain procedure, you
must activate again the drain system:
Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water

14.9 Frost precautions

If the appliance is installed in an area
where the temperature can be less than

15. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
15.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
2
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
2. Close the water tap.
3. Put the two ends of the inlet hose in
4. Empty the drain pump. Refer to the
5. When the drain pump is empty,
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
•
•
•
mains socket.
a container and let the water flow out
of the hose.
emergency drain procedure.
install the inlet hose again.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
- The appliance does not fill with
water properly.
- The appliance does not drain
the water.
- The appliance door is open or
not closed correctly. Please check the
door!
- The mains supply is unstable.
Wait until the mains supply is stable.