Recording Guitar Mixed With The Line Inputs - Edirol UA-3 Manual Del Usuario

Recording guitar mixed with the line inputs

With these settings, the guitar will be mixed with the line inputs and recorded on your computer.
Make connections as shown in the following diagram.
MIDI sound module / CD / MD / DAT
LINE OUT
Audio cable
Set to "INPUT + GUITAR/MIC"
Set the recording sample rate of your recording application to the desired setting. (The available sample rates will de-
pend on your application. For details, refer to the owner's manual for your application.)
Use the Line input adjustment slider and Guitar/Mic input adjustment slider to adjust the balance. If the
LED above the slider lights red, use the slider to lower the input level. If
you can get it before causing the LED to light.
UA-3
Monitor
speakers
Audio cable
The GUITAR and LINE IN
will be mixed and output.
LINE
LINE
IN OUT
UA-3
Guitar
Computer
LINE IN
USB
port
USB cable
The GUITAR and LINE IN
will be mixed and recorded
to the computer.
USB
port
Stereo
Headphones
The GUITAR and LINE IN
will be mixed and output.
LINE input signal flow
GUITAR input signal flow
you use the slider to adjust the level so it is as high as
Appendices
• It is not possible to simultaneously
record both a digital source (such as
CD) and an analog source (such as
guitar or mic). Either use the included
software to record them separately, or
record the digital source first and then
record the analog source as described
in Recording guitar sounds (p. 113).
• If you change the position of the
Recording input select switch,
you should turn down the volume
of any monitor speaker system
that is connected.
115