Cameo CLMPARFOOTPLUS Manual De Usuario página 9

OPERATION:
COLOUR:
Mode for static colours. All 4 Multipar projectors emit light in the same colour.
Press the MODE switch until the red LED lights up (COLOUR). Using the buttons UP and DOWN, you can then
select the desired colour preset (short press).
SOUND:
In the music control operating mode (Sound Mode), the lighting system responds to noise (bass impulses), in
order to produce different colour combinations in succession.
Press the MODE switch until the green LED lights up (SOUND). The MIC SENSITIVITY controller on the back of the
pedal is used to set the sensitivity of the noise-sensitive microphone which is integrated into the pedal. Turning
it to the right increases and turning it to the left reduces the sensitivity. Using the buttons UP and DOWN, you can
then select one of the integrated presets (short press).
PROGRAM:
Operating mode for automatic program sequence (varying programmed colour effects).
Press the MODE switch until the yellow LED lights up (PROGRAM). Using the buttons UP and DOWN, you can then
select one of the integrated programs (short press).
NOTE: The connection of a Cameo Multipar lighting system to the multi PAR foot + pedal must be done via a
5-pin XLR cable with fully allocated connector pins and parallel wiring, because it will supply both the power for
the pedal and the control signal (suitable cable included).
9