Basic Operations; Switching Power On/ Off; Selecting A Zone And Channel /Group Id - Kenwood TK-7360 Manual De Instrucciones

S P
WITCHING OWER
Press to switch the transceiver ON.
• A beep sounds and the display illuminates. If the Power-on tone select is set to OFF, the
beep will not sound.
• If the Transceiver Password function is programmed, "PASSWORD" will appear on the
display. Refer to "Transceiver Password", on page 6.
Press again to switch the transceiver OFF.
■ Transceiver Password
To enter the password:
1 Press / to select a digit.
• When using a keypad, simply enter the password digits and proceed to step 4.
2 Press C> to accept the entered digit and move to the next digit.
• Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
3 Repeat steps 1 and 2 to enter the entire password.
4 Press S or
• If you enter an incorrect password, the transceiver remains locked.
A
DJUSTING THE
Press the Volume Up key to increase the volume. Press the Volume Down key to decrease the
volume.
If Squelch Off has been programmed onto a key, you can use that function to listen to background
noise while adjusting the volume level.
S Z
ELECTING A ONE AND
Select the desired zone and channel/group ID using the keys programmed as Zone Up/ Zone Down
and CH/GID Up/ CH/GID Down.
• You can program names for zones and channels/group IDs with up to 10 characters.
■ Home Channel/Group ID
You can select your Home channel/group ID by pressing Home CH/GID. Press the key a second
time to return to your previous channel/group ID.
■ Direct Channel/Group ID
You can quickly select a commonly used channel/group ID by pressing Direct CH/GID 1 ~ Direct
CH/GID 4. Press the same key a second time to return to your previous channel/group ID (if the
key assignment Direct CH/GID return is confi gured as "Enabled").
6

BASIC OPERATIONS

ON/ OFF
to confi rm the password.
V
OLUME
C
HANNEL
/G ID
ROUP