Discharging Procedures; Cleaning; General Safety Practices; Basic Operation Procedures - Skymsen LAR-25LMB Manual De Instrucciones

Ocultar thumbs Ver también para LAR-25LMB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.3 Discharging Procedures

To discharge processed product from Blender proceed as
follows:
1- Turn machine OFF.
2- Remove Lid # 01 (Pic. 01).
3- Press Lock Pedal # 06 (Pic. 01) down.
4- Tilt Cup # 02 (Pic. 01) holding its handle and discharge
processed product as needed.

3.4 Cleaning

The new Blenders cup has stamped ribs that facilitate cleaning.
Wash the Lid # 01 and the Cup # 02 (Pic. 01) with water and neutral
soap. Wipe up the other parts with a damp cloth.
IMPORTANT
Never do cleaning with machine plugged in. Always unplug
machine before cleaning. When washing inside the Cup be careful
with the blade.

4. General Safety Practices

If any item from the GENERAL SAFETY NOTIONS section is not
applicable to your product, please disregard it.
The following safety instructions are addressed to both the
operator of the machine as well as the person in charge of maintenance.
The machine has to be delivered to the operator in perfect conditions of
use by the Distributor to the user. The user shall operate the machine only
after being well acquainted with the safety procedures described in the
present manual. READ THIS MANUAL WITH ATTENTION.

4.1 Basic Operation Practices

4.1.1 Dangerous parts
05
IMPORTANT

Publicidad

Tabla de contenido
loading

Tabla de contenido