Electrical Requirements - Sears Kenmore 665.1361 Serie Manual De Uso Y Cuidado

Cutout dimensions :
\
3"
(7
151/4 mm
(38.7 cm)
_ 1/4" rain.
(87 cm)
A. Grounded electrical outlet must be a minimum of 3" (7.6 cm) away
from surrounding cabinets or nearby walls as shown. It can be
placed either to the left or the right side of the product.
Clearance dimensions
B -_l A
t
A. Leave 6" (15.2 cm) of clearance space to the right side of the
compactor in order to remove the compactor bags.
B. Leave 23" (58.4 cm) of clearance in front of the compactor in
order to fully open or remove the compactor drawer:
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Recommended Grounding Method
This compactor is for use on a single phase, 115-volt, 60 Hz, AC
only 15- or 20-amp fused and properly grounded circuit and is
equipped with a grounding plug as shown below. It is
recommended that a separate circuit serving only this appliance
be provided.
This compactor must be grounded while in use to reduce the risk
of electric shock. The compactor is equipped with a three-
conductor cord and 3 prong grounding-type plug to fit the proper
grounding-type receptacle. The green (or green and yellow)
conductor in the cord is the grounding wire. Do not connect the
green (or green and yellow) wire to a live terminal.
NOTE: Proper installation is your responsibility. Make sure you
have everything necessary for correct installation. It is the
personal responsibility and obligation of the customer to contact
a qualified installer to assure that electrical installation meets all
national and local codes and ordinances.
Tools needed
•
Level
•
%6" hex-head socket
wrench
• Phillips No. 2 screwdriver
• Scissors
• Tape measure
• Flat-blade screwdriver • Utility knife
•
Pliers
IMPORTANT:
•
Do not grasp control panel to move compactor.
• Slide compactor onto cardboard or hardboard before moving
compactor across floor to prevent floor covering damaging.
• Do not allow the rear frame of the compactor to touch the
floor covering when lifting or moving compactor.