Urmet YOKIS 1083/85 Manual De Instalacion Y Uso página 8

TERMINAL PINS DESCRIPTION
}
CP+
Floor call /Yokis Signals
CP-
}
S+
Yokis Signals
S-
V+ Device power input (positive input)
V- Device power input (negative input)
YOKIS INTERFACE CONFIGURATION
Confi gure fi rst all Yokis modules present in the system using the 8-channel remote control (TLC8CP), then it
will be possible to copy the confi guration of the 8-channel remote control to the interface (1083/85).
La modalità è la seguente:
a) on the Yokis interface:
1) Briefl y press the button (1)
2) The yellow led begins to fl ash, then stays on with a steady light.
3) The blue LED fl ashes while waiting for copying (approximately 30 seconds)
b) on the 8-channel remote control:
1) Apply 10 quick presses on any button.
2) The remote control LED will fl ash at a fast rate.
3) While the LED is fl ashing, briefl y press any button 14 times.
4) The yellow LED going off on the interface indicates the end of the copying process.
YOKIS INTERFACE RESET
The reset procedure will delete all confi gurations previously stored on the device.
1. Hold down the button (1) for more than 5 seconds.
2. The yellow LED begins to fl ash and then stays on with a steady light.
3. The blue LED fl ashes 3 times.
4. The yellow LED going off on the interface indicates the end of the resetting process.
YOKIS HOME AUTOMATION PARAMETER SETTING ON THE
MONITOR
Before using Yokis Home Automation functions, a number of confi guration parameters must be set on the
MODO monitor.
• By selecting the icon
settings (settings menu) can be accessed.
• Select to open the home automation settings menu. The menu is password-protected. The default
password is 1937 and cannot be changed. The password prompt page is shown below.
8
}
from power supply provided with the monitor
from the main menu, the general menu containing all video door phone
RESET
DS1083-069A