Operations; Playing A Record; Adjusting The Pitch - Sony PS-LX300H1 Manual De Instrucciones

Operations

Playing a Record

1
2
3
1
Place a record on the platter.
Note
Place only one record on the platter at a time. If two or
more records are stacked on the platter, the stylus will
not make proper contact with the grooves and the
quality of reproduction will be impaired.
2
Press POWER to turn on the record turntable.
The strobo lamp lights up.
3
Set the PITCH CONTROL to the center position
and press 33 or 45 to select the platter speed.
The indicator for the selected speed lights up.
4
Press START/STOP.
The platter starts rotating.
If you select 33 r/min when the turntable is
connected to a 50 Hz power source, the innermost
row of the strobo dots should appear to stand
still.
50 Hz
60 Hz
5
Remove the protective cover from the cartridge.
6
Set the cueing lever to the up position.
Move the tone arm to the desired position over
the record.
7
Set the cueing lever to the down position.
The tone arm descends slowly to the record and
playback begins.
6 EN
8
Adjust the volume on your amplifier.
To stop playing
1 Set the cueing lever to up position to lift up the
tone arm, return the tone arm to the arm stand.
Attach the protective cover onto the cartridge to
6,7
prevent damage to the stylus.
2 Press the START/STOP button.
6
The platter stops rotating.
3
3
Press POWER to turn the turntable off.
6
4
To pause playback
5
Lift the cueing lever to raise stylus off the record
during playback.
To listen to a different part of the record
1 Lift the cueing lever to raise stylus during
playback.
2 Move the tone arm to the position you desire.
3 Lower the cueing lever.
To play a 17-cm record
Place the supplied 45 r/min adaptor on the spindle.
When you have finished using the adaptor, put it back
in the adaptor tray.

Adjusting the pitch

You can make fine adjustments to the platter speed by
using the PITCH CONTROL.
Slide toward "FAST" to increase the platter speed.
The strobo dots for the original speed flow backward.
Slide toward "SLOW" to decrease the platter speed.
The strobo dots for the original speed flow forward.
If the strobo dots do not stand still when the PITCH
CONTROL is set to the center position
Use the platter speed controls (33 or 45) on the bottom
of the turntable to adjust the platter speed so that the
respective strobo dots appear to stand still.
Turn toward + to increase the platter speed.
Turn toward – to decrease the platter speed.
33
45
33
45
45
33