Kenwood KCA-S220A Manual De Instrucciones página 3

• If you wish to adjust the cable length in accordance with the installation location of the switching unit, such as in the trunk
space, the disc changer extension cable may be used instead of the connection cable
• When a control unit belonging to Group A is used, you cannot use both TO CHANGER 2 terminal and AUX terminals at the
same time. For more details, see <Setting the AUX Switch> (page 5).
If you want to connect a stack CD changer
Changer control output
Control unit
Disc changer
• Connect the stack CD changer to the terminal labelled TO CHANGER 2.
• Up to two disc changers can be connected.
• The O-N switch on the disc changer and the disc player should be set to "N". If you set it to "O", the equipment will not
function correctly.
• The total length of the cable between the units should not be more than 13 m (43 ft).
Control unit
KCA-S220A
Not more than 13 m (43 ft)
• If the voltage is low and the internal temperature of the switching unit is low, switching may fail to work properly in some
cases.
• The AUX switch on the stack CD changer should be switched "OFF" before using the equipment. The AUX terminal on the
KCA-S220A switching unit is the one that should be used.
AUX IN
TO HEAD UNIT
Connection cable "
Connection cable (supplied with the Disc changer)
Disc player
Stack CD changer
Stack CD Changer
"
To the external unit
Switching unit !
(Rear side)
TO CHANGER 1 TO CHANGER 2
TO HEAD UNIT TO CHANGER 1 TO CHANGER 2
Switching unit !
(Front side)
Extension cable (CA-C2EX: Optional)
Connection cable (supplied with the stack CD changer)
Disc Player
.
English
3