Overheat Warning - Panasonic EY75A7 Manual De Instrucciones

EN
• Jobs requiring limited
• Jobs requiring minimal
* i.p.m. = Impact per minute.
•
* i.p.m. = Impact per minute.
Avoid repeatedly depressing the switch
when the bolts and screws are securely
fastened.
Not doing so may cause a delay in rotation
starting, or the Impact Power mode
starting for circuit protection.
Press the light button and set illumination
condition.
EY75A7:
0 – 950 rpm
and
0 – 1900 i.p.m.
EY75A8:
0 – 1000 rpm
and
0 – 1900 i.p.m.
torque.
exterior surface.
0 – 2500 rpm
and
0 – 1200 i.p.m.
of self-drilling screw.
(dia. 4 mm × 15 mm or
smaller)
Illuminated
Illuminates by pressing button.
The light turns off when the tool
has not been used for more
than 5 minutes or just after
attaching the battery pack.
Depress the trigger switch and
operate the tool once.
Interlocking trigger
Illuminates while depressing the
trigger switch.
Off
Do not use it as a substitute for a
enough brightness.
DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
radiation exposure.

Overheat warning

Off
(normal
operation)
Indicates operation has been halted due to
motor or battery overheating.
• If the overheating protection feature
activates, allow the tool to cool thorough-
ly (at least 30 minutes). The tool is ready
for use when the overheat warning lamp
goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to
activate repeatedly.
• The performance of the EY9L42 deterio-
to work conditions and other factors.
- 12 -
Illuminated: Flashing:
Overheat Overheat
(motor) (battery)