Installing The Wr-1 Safari Wireless Receiver Modules; Operating Safari's Wireless System; Manual Scan - Phonic SAFARI 2000 Manual Del Usuario

Installing the WR-1 Safari Wireless Re-
ceiver Modules
We recommend that an authorized Phonic repair facility or dealer/
distributor carryout the steps below:
1. Remove all power cables and turn the Safari 2000 off.
2. Unscrew the protective faceplate on the wireless receiver slots
and remove it.
3. Place the WR-1 into an available wireless slot and push the
WR-1 into the slot until the WR-1 faceplate is flush with the
back panel.
4. Screw the WR-1 into place.
Frequency Band Lock Button
Auto Scan Button
Communication Status
Infrared
4
Channel LED
Power Switch/Volume Knob
Volume Gain
Noise Status

Operating Safari's Wireless System

One-Touch Auto Scan
1. Power-on the Safari One-Touch Autoscan wireless receiver
(WR-1) by turning the volume knob clockwise. You should hear
a click sound from the knob.
2. Power-on your handheld microphone (WM-1) or beltpack unit
(WB-1)
3. Hold the WM-1 / WB-1 close against the receiver WR-1 and
push the Scan button on the WR-1 for 4 to 5 seconds until
the numeric channel LED digits start to automatically change,
indicating that the autoscan is finding the best wireless channel.
4. The autoscan process is finished when the LED display stops
at the optimal channel. At this point, the RF LEDs will activate.
If the RF LEDs on the WR-1 do not light on, the connection has
not been established successfully. To reinforce the connection,
click the Lock button while holding the WM-1 or WB-1 close to
the receiver.
5. Upon a successful connection, the AF LEDs on the WR-1 will
activate as you speak into the microphone.

Manual Scan

1. Power-on the Safari One-touch Autoscan wireless receiver
(WR-1) and the microphone transmitter (WM-1 or WB-1).
2. Push the Scan button on the WR-1 for 2 seconds. The numeric
LEDs on the WR-1 will begin to blink. To manually select fre-
quency, continue to click the Scan button until you reach the
desired channel.
3. Hold the WM-1 / WB-1 close against the receiver and push
the Lock button to confirm the channel and establish the link
between the microphone transmitter and receiver. At this point,
the RF LEDs will activate and the AF LEDs will respond to the
microphone signal. If the connection is not established, reat-
tempt the manual or autoscan process.
Safari 2000