Hama 00119495 Instrucciones De Uso página 4

Note – Capacity
• The capacity is always shown when the Power Pack
is charging.
• Each status LED corresponds to 25% of the
capacity. When an LED is permanently illuminated,
this indicates that this capacity level has already
been reached. The Power Pack is charged to at
least 75% if three LEDs are illuminated, and the
fourth is ashing.
• If all four status LEDs light up, the full capacity is
available.
• Press the on/off button (3) on the power pack to
switch it on and to check its current charge level.
• To switch the power pack off, press and hold the
on/off button (3) until the status LEDs go out.
Warning – Battery
• Only use suitable charging devices or USB connections
for charging.
• As a rule, do not charge devices or USB connections that
are defective and do not try to repair them yourself.
• Do not overcharge the product or allow the battery to
completely discharge.
• Avoid storing, charging or using the device
in extreme temperatures and extremely low
atmospheric pressure (for example, at high
altitudes).
• When stored over a long period of time, batteries should
be charged regularly (at least every three months).
4.2 Charging terminal devices
• Connect the integrated Micro-USB connection cable
(4) or the Lightning connection cable (5) to the
terminal device you wish to charge.
• To start charging, press the on/off button (3). The
status LEDs show the remaining capacity when the
Power Pack is charging.
• The current battery status of your terminal device will
appear on this device.
• Press the on/off button on the power pack to stop
charging and to switch it off. The status LEDs should
switch off.
• The Power Pack will automatically switch off after 25
seconds if it is not connected to a terminal device.
Warning – Connecting terminal devices
• Before connecting a terminal device, check
whether the power output of the charger can
supply su cient power for the device.
• Ensure that the total power consumption of all
connected terminal devices does not exceed
3400 mA.
• Please refer to the instructions in the operating
manual of your terminal device.
• It is essential that you observe these speci cations
and the safety instructions regarding the power
supply of your devices.
Note
• Please note that it is not possible to charge and
discharge the power pack simultaneously.
3