Craftsman 917.388191 Manual Del Propietário página 14

,_ WARNING: To avoid serious injury,
before performing any service and
adjustments:
t .. Release control bar and stop engine..
2. Make sure the blade and alI moving
parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See '%0 ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
Mowing r'-q Mowing ___.
,-_. position _ I ,p,,, position / /
\./ , , \ \/ , ,
\ "t, x% _ _ \ "£ x'-. _ i
i ! t
Ha
Mounting,..1 "" "_ LU bracket -
pin LOW POSITION HiGH POSITION
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibility that objects will
be thrown out of the rear of the mower
into the operator mowing position. If the
deflector becomes damaged, it should be
replaced.
TO ADJUST' HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all wire
tie(s) securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mounting pins on handle
bracket°
6. Reassemble upper handle and all
parts removed from lower' handle°
SQUEEZE
TO ADJUST
""--_ Lower ha
Mounting
Handle
.i bracket Hairpin cotter
Lower
\
\
ROTATE
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury° if you
believe that engine is running too fast or
too slow, take your mower to a Sears or
other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due to sus-
pected carburetor problems, take your lawn
mower to a Sears or other qualified service
center for repair and!or adjustment.
IMPORTANT: Never tamper with the
engine governor, which is factory set
for proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments,
14