Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO INSTALL THIS UNIT WITH POWER SUPPLY WIRE:
1.
Drill 2 holes of 6 mm diameter according to the
measures shown in picture. Insert the screw
anchors in the drilled holes.
2.
Fix the installation clip to the below hole and use it
to fix the dryer. Screw the dryer to the wall using
the upper hole. Insert the screw covers.
3.
Connect with general power and move power
switch to "ON" position.
HOW TO INSTALL THIS UNIT WITHOUT POWER SUPPLY WIRE:
1.
Follow first step of method above.
2.
Loosen the 6 screws from the back side to
remove front cover.
3.
Remove the power supply wire. Open the wire
entry hole and pull the wall wire through that
hole. Connect the wall wire and fix againg the
cover fixing the screws previously retired.
4.
Fix the dryer to the wall by using the
installation clip (previously screwed on below
hole) and screw the dryer to wall using the
upper hole.
5.
Turn on general power and move power switch
to "ON" position.
x2
x2
x2
1
2
3
4
5
2
Publicidad
