Performance Data Sheet - Laica Stream J406H Manual De Instrucciones

PERFORMANCE
DATA SHEET
Filtered water pitcher
Model Stream - code: J406H, J431H, J432H, J433H, J434H, J435H
Model Carmen - code: JI06H, JI30H
Model Kiara - code: JE06H, JF25H
Model Dream - code: JA06H
Model Best - code: JA18H
Model Eden - code: JH46H, JH47H, JH48H, JH49H, JH50H
Replacement filter:
Laica bi-flux cartridge - code:
M1M, M3M, M6M, C3M
Laica classic cartridge - code:
M3A3
This product has been tested and certified by the
Water Quality Association according to NSF/ANSI 42
for the reduction of Aesthetic Chlorine and to NSF/
ANSI 53 for the reduction of Copper, as verified and
substantiated by the test data, and to CSA B483.1.
Laica filtration system This system has been tested according to NSF/ANSI 42 for
reduction of the substances listed below. The concentration of the indicated substances
in water entering the system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system, as specified in NSF/ANSI 42."
NSF/ANSI Standard 42 Aesthetic Effects
Minimum Average
Substance Percent Percent
Reduction Reduction
Aesthetic
Chlorine – Classic 81.9% 91.6%
Cartridge
Aesthetic
Chlorine – Biflux 76.2% 84.2%
Cartridge
Laica filtration system: this system has been tested according to NSF/ANSI 53 for the
reduction of Copper. The concentration of Copper in water entering the system was
reduced to a concentration less than or equal to the permissible limit for water leaving
the system, as specified in NSF/ANSI 53.
NFS/ANSI Standard 53 Copper reduction
Bi-flux Bi-flux
Cartridge Cartridge
Copper 6.5pH Copper 8.5pH
Average Influent Conc 3,3 3,1
Average Effluent Conc 0,45 0,63
Average % Reduction 86,3 79,4
Lowest % Reduction 78,5 60,7
Max Effluent Conc 0,70 1,20
USEPA Level 1,3 1,3
9
Maximum
Influent
Permissible
Challenge
product water
Concentration
concentration
(mg/L)
(mg/L)
≥ 50%
2.0
reduction
≥ 50%
2.0
reduction
Classic Classic
Cartridge Cartridge
Copper 6.5pH Copper 8.5pH
3,3 3,1
0,49 0,62
85,0 79,8
63,1 63,9
1,20 1,10
1,3 1,3
Operating Requirements: Filter System capacity 40 - Gallons/150 liters/60 days
Operating temperature: Min 37°F/3°C – Max 68°F/20°C
Rated Service Flow: 1.5 gpd
Manufacturer's warranty: 2 years
Please refer to instruction manual for general operation and maintenance requirements
and warranty information.
While testing was performed under standard laboratory conditions, actual performance
may vary.
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
Replacements components:
Model numbers F0M, M1M, M3M, M6M and C3M (bi-flux), F0A3, M1A3, M6A3, M3A3
(Classic).
The replacement components referenced above generally retails around $7.00 each.
Cartridge life indicator replacement generally retails around $7.90 each.
10